misfit410 Posted July 19, 2018 Share Posted July 19, 2018 Since getting a really good second printer cheap I decided to tackle something huge, a 13" Hulk I wanted to go high quality without getting too insane so I went with a 0.15mm layer height (most people do .2, .05 is the finest you can typically pull off but it would have printed for a week per part) each part was about 4-5 hours at this quality I used Ace Hardwares generic Wood fill to fill up the gaps, sanded it down then applied rustoleum primer/filler, let dry, sanded again and another coat of white primer. Did a flesh base coat and it's drying right now.. started this on Thurs of last week, had an issue printing the left arm and didn't get it successful until Monday, and have been working on it since then as time allows. Hoping to have it fully painted at some point on Saturday but I want to take my time and really do it right. I'm already deeming this $199 second printer money well spent. Quote Link to comment Share on other sites More sharing options...
gamer.tv Posted July 20, 2018 Share Posted July 20, 2018 That is just remarkably cool. Quote Link to comment Share on other sites More sharing options...
johnny Posted July 20, 2018 Share Posted July 20, 2018 that's badass Quote Link to comment Share on other sites More sharing options...
Hurdyb1 Posted July 20, 2018 Share Posted July 20, 2018 Damn! Quote Link to comment Share on other sites More sharing options...
Remarkableriots Posted July 20, 2018 Share Posted July 20, 2018 Very cool! Quote Link to comment Share on other sites More sharing options...
brandino Posted July 20, 2018 Share Posted July 20, 2018 Any reason behind the different color filaments? Quote Link to comment Share on other sites More sharing options...
DarkStar189 Posted July 20, 2018 Share Posted July 20, 2018 Wow that looks great! Quote Link to comment Share on other sites More sharing options...
Greatoneshere Posted July 20, 2018 Share Posted July 20, 2018 Really fantastic job!! Quote Link to comment Share on other sites More sharing options...
misfit410 Posted July 20, 2018 Author Share Posted July 20, 2018 4 hours ago, brandino said: Any reason behind the different color filaments? Two reasons honestly. 1. Using two different 3d Printers and I don't typically have more than one roll of the same color 2. I ran out of the black filament after doing the waist (and had a few failures on the left arm) so I broke out a brand new roll of the blush. Normally I would try to do an entire print in one color but knowing I was going to fill and prime this one I figured it wouldn't matter once it was done. Quote Link to comment Share on other sites More sharing options...
misfit410 Posted July 24, 2018 Author Share Posted July 24, 2018 Almost there, airbrush died before I really got to use it for more than one coat..got a replacement part on the way but until it gets here, it's almost done. After the airbrushing I def need to go back and tweak the eyes and facial details. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.